RLH Industries 16 Channel T1 Over Ethernet Multiplexer System Guia do Utilizador descarregar pdf (Página 34)

Setting the Trap IP

The iMux can assign four sets of the Server IP address for sending the Traps. Enter the IP address and port

number information on each line as required. Three community names may also be set. Default names are pre-

configured, but may be changed using the menu items [F5], [F6] and [F7].

•

The default Read Community Name is public

•

The default Write Community is private

•

The default Trap Community is public

Press [F8] to enable the Send SNMP Authentication Failure Trap function for sending the trap when

the authentication fails.

Software Upgrade Configuration

The iMux can support two kinds of the System Software Upgrade: Remote Server and Local File.

Remote Server

Press the space bar to change these selections

For Remote server source selection:

[F3] Access Protocol: Select the protocol you want to use. You may use either FTP or TFTP.

[F4] Server IP Address: Enter the server IP address where the new firmware is saved.

34! RLH Industries, Inc. • 866-DO-FIBER • www.ﬁberopticlink.com! System Conﬁguration

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 121 122

Sem comentários

RLH Industries 16 Channel T1 Over Ethernet Multiplexer System Guia do Utilizador Página 34